Weidmuller Insulated Crimp Bootlace Ferrule, 8mm Pin Length, 1mm Pin Diameter, 0.5mm² Wire Size, White

Stripax plus pliers allow you to cut, strip wires between 0.5 and 2.5 mm² and crimp wire-end ferrules with the same cross section.
Wires can be cut and stripped without clutch crimping the wire-end ferrules. Crimping complies with EN standard 50027 and with DIN 6228. Automatic feeding of wire-end ferrules.
The wire-end ferrules are supplied in packs of 500 split into strips of 50 parts each (see stock numbers 204-6682, 204-6698, 204-6705, 204-6711 and 204-6727)
Stock number 204-6676 is a kit consisting of a carry case containing 1 x pliers, 250 x 1mm² wire-end ferrules and 250 x 1.5 mm² wire-end ferrules.
Stock number 286-1009 is a STRIPAX PLUS 2.5 crimp tool

Need a sure way to connect wires? Go with this crimp bootlace ferrule from Weidmuller. Simply thread your conductor through the pin and crimp it for termination in a snap. The unit's PP insulation collar protects your connection for efficient performance. There are 50 pieces on a 14mm strip, so you'll have plenty of ferrules on hand in your toolbox. Pair this component with the Weidmuller STRIPAX PLUS crimping tool (452-473) for a lasting connection.

• Highly conductive copper pins for reliable signal relays
• White colour-coded insulation for simple identification of matched conductor size
• Pin length of 8mm gives you a good contact surface

• Industrial control panels
• Electrical enclosures
• Consumer electronics
• Commercial and domestic appliances

Using a ferrule that's too big for your wire can result in poor connections as the pin may not sit firmly around the conductor once crimped. If the ferrule is too small, you'll damage the strands when trying to force them through the pin.