Idec Push Button Tool Kit

Product Description:
The Idec fitting tool kit is made up of three component parts required to fit and maintain Idec 8mm sub-miniature push button switches.
MT-004: is a locking ring wrench that is used to tighten the locking ring at the point of installation of the control unit into the panel. It is important to note not to exceed 0.29 N m when tightening the locking ring to avoid damage.
MT-101: the stainless steel lens removal tool can be used to remove both the lens and buttons.
OR-66: This part is a rubber lamp holder tool that is used to remove and install LED lamps.

Features and Benefits:
Locking ring wrench.
Lens Removal tool.
Lamp holder tool.

Product Application Information:
To be used for the installation and maintenance of Idec A8 series Miniature control units.