FTDI Chip Breakout Module ZigBee UMFT230XB-01 XBee

Versions Available
(757-0054) UMFT201XB-01 - FT201XQ Breakout Board
(757-0067) UMFT230XB-01 - FT230XQ Breakout Board

This range of FTDI breakout boards are designed to convert USB to serial or parallel interfaces. The UMFT201XB-01 (757-0054) bridges USB to I²C and the UMFT230XB-01 (757-0067) bridges from USB to a UART IC.

The UMFT201XB bridges from USB to I²C two-wire serial bus interface
The UMFT220XB bridges from USB to Parallel 4-Bit FT1248 Interface
The UMFT230XB bridges from USB to Basic UART (Universal Asynchronous Receiver/Transmitter)
The breakout board converts USB 2.0 Full-Speed to a serial interface
Serial signals on a 2.54mm (0.1”) pitch 10-pin female connector
The module plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector
The serial interface operate at +3.3V
Input/Output pins are 5V tolerant