Fluke I430-FLEXI-TF-II-4PK, Accessory Type Rogowski Coil

The i430-Flexi-TF-II flexible AC current probe is optimized for current measurement on thick and hard to reach conductors. The i430-Flexi-TF-II is a flexible AC current probe for use with the Fluke 430 series Power Quality Analyzers including Series II.

Measuring range: 0.5 to 6000 A ac
Bandwidth (-3 dB): 10 Hz to 10 kHz
Output signal: 86.6 mV at 1000A/50Hz (on 1 MΩ), 85.0 mV at 1000A/50Hz (on 50 kΩ)
Maximum non-destructive current: 100 kA (50/60 Hz)
Transducer length: 610 mm (24 in)
Transducer diameter: 7.5 mm (0.3 in)
Minimum bending radius: 38 mm (1.5 in)
Cable length from transducer to BNC: 2.5 m (98.4 in)
Complies with: IEC 61010-1: Pollution degree 2, IEC 61010-2-032: 1000V CAT III/ 600V CAT IV, IEC 61010-031

Instruction Sheet

Get precise measurements at your fingertips with this flexible current sensor from FLUKE. It's designed to read current values on thick and hard-to-reach conductors. Thanks to a current measurement range between 0.5 and 6000A AC, you can depend on it to provide reliable results across a wide spectrum of conditions. An output signal of 86.6mV at 1000A/50Hz means the unit can easily connect to various measuring devices, such as oscilloscopes and multimeters. For efficiency, this sensor has a maximum non-destructive current of 100kA at 50/60Hz.

• Minimum bending radius of 38mm means it's a flexible fit for awkward spaces
• Broad operating temperature range between -20°C and +70°C makes it suitable for harsh environments
• Operating altitude of 3000m for use in elevated setups

• Facilities management
• Healthcare industry
• Power distribution
• Data centres

As it doesn't need batteries or an external power source, setup of the unit is a cinch. Just connect it to the desired input on a power quality analyser in the FLUKE 430 series (530-0995).