Monitran Connector for use with MTN/1185-2P Series

  • RS Stock No. 533-2245
  • Mfr. Part No. MTN/MH002
  • Manufacturer Monitran
Technical data sheets
Legislation and Compliance
RoHS Status: Not Applicable
COO (Country of Origin): GB
Product Details

MTN/1100 Series General Purpose

Used for Data-collector, heavy industry, paper machinery
100mV/g +/-10% Nominal at 80Hz
Frequency from 2Hz up to 10KHz
+/-80G Dynamic acceleration range
Bias Voltage nominal 12 Vdc
Available with TNC Connection (533-2239) or integral cable (533-2251)
IP 67 Stainless Steel body Case
533-2251 includes a 5 meter PTFE Cable - stainless steel over braided
Mounting torque: 8Nm
To use with Glue or M8 Mounting stud
Dimensions (D x L): 22x48mm

Approvals

EEx ia lic BAS02ATEX1057/3

Accelerometers

Vibration sensors use solid-state piezoelectric accelerometers to detect the level of vibration in rotating elements like bearings and gearboxes on machinery such as motors, generators, pumps, fans and compressors. Regular vibration measurements on all critical machines as part of the maintenance regime can detect early signs of failure and provide a way to eliminate these problems. Bearing wear, poor balance and loose mounting all lead to the failure of rotating machinery. Unexpected machinery failure leads to unplanned maintenance costs, loss of production plus potential Health and Safety hazards. They are rugged, adaptable to all types of machinery and conditions including operation in hazardous areas, easy to install and require no maintenance. Used in conjunction with off- and on-line vibration analysers they yield valuable diagnostic information on the machinery's condition and reveal where and when failure may occur allowing pre-emptive maintenance intervention. The dc (velocity) outputs integrate this complex signal into a simple dc signal of 4-20mA proportional to the overall vibration of the machine, ideal for monitoring with all types of industrial controllers.

Specifications
Attribute Value
Accessory Type Connector
For Use With MTN/1185-2P Series
Discontinued product
Related Products
Description:
The Siemens M12 plug connector is a PRO (PROFINET) high protection, 4-pole D-coded connector. This is used for connecting electrical cables to SCALANCE X208PRO, ET200 PRO PN or ET200 eco PN for fast assembly with the fast connect system. It ...
The Siemens SIMATIC S7-300 front panel connector enables ...
Description:
The Siemens SIMATIC S7-300 front panel connector enables quick and easy interconnection to PLC's and expansion modules. The 20 pin and 40 pin connectors may be coded to fit certain module types to help prevent incorrect connection of wiring. This ...
The Wago Fieldbus connector is an innovation that ...
Description:
The Wago Fieldbus connector is an innovation that links a PROFIBUS device to a PROFIBUS line. It has a Stecker 9-Pin D-sub male connector.BUS connectors:Rewireable bus interface connectors are suitable for Bitbus, CAN-Bus, Interbus-S (Fieldbus), and Profibus systems. Compact and ...
The Wago CANopen connector is an innovation that ...
Description:
The Wago CANopen connector is an innovation that links a CANopen device to a CANopen line It has Buchse D-Sub 9 female connector. BUS connectors:Rewireable bus interface connectors are suitable for Bitbus, CAN-Bus, Interbus-S (Fieldbus), and Profibus systems. Compact and ...