DesignSpark Enclosure Mounting & Installation for use with DesignSpark Raspberry Pi Case

  • RS Stock No. 122-3465
  • Mfr. Part No. ASM-1900048-21
  • Manufacturer DesignSpark
Technical data sheets
Legislation and Compliance
RoHS Status: Not Applicable
COO (Country of Origin): GB
Product Details

VESA Mounting Brackets for DesignSpark Raspberry Pi 3 cases

These VESA mounting brackets enable you to mount a DesignSpark Raspberry Pi 3 case to the back of a display or monitor using the VESA attachment points. Note: Pi case not included.

Each bracket includes a locking clip which can be used to prevent the SD card from being removed from the Raspberry Pi.

Within the mounting bracket there is space to add a 2.5 inch hard drive for additional memory for your Raspberry Pi project.

Includes two M3 screws to attach a DesignSpark case to the mounting bracket.

These brackets are available in three colours:

• Clear bracket RS 122-3463
• White bracket RS 122-3464
• Black bracket RS 122-3465

The VESA mounting brackets are suitable for the following DesignSpark Pi cases:

• Clear case RS 103-4296
• White case RS 103-4297
• Black case RS 103-4295
• Black case RS 103-4300

Specifications
Attribute Value
Dimensions 110.09 x 110.09 x 18.5mm
Length 110.09mm
Width 110.09mm
Height 18.5mm
For Use With DesignSpark Raspberry Pi Case
Temporarily out of stock - back order for despatch 14/01/2020, delivery within 4 working days from despatch date
Price Each
MYR 10.91
units
Per unit
1 +
MYR10.91
Related Products
This case is designed to house and protect ...
Description:
This case is designed to house and protect the Arduino UNO and Ethernet Shield. UNO Board and Ethernet Shield are held via clip-in grooves - No Screws RequiredAll cut-outs are pre-cut into the caseSupplied with Rubber feetGloss Finish.
StarCASE is a multipurpose range of plastic enclosures. ...
Description:
StarCASE is a multipurpose range of plastic enclosures. These ergonomic enclosures are perfectly suitable for modern industrial electronics. The enclosures can be mounted on a wall, bulkhead, ceiling or machine. The enclosures can also be mounted without opening the lid ...
The Takachi AWN series is a heavy duty ...
Description:
The Takachi AWN series is a heavy duty waterproof enclosure ideally suited to tough outdoor environments. These enclosures have diecast side plates and an extruded aluminium body with fins on either side which act as a heat sink. Application examples ...
The Takachi MB series is a simple and ...
Description:
The Takachi MB series is a simple and low-cost case. It has a 2-piece construction consisting of a base and cover made from folded aluminium sheet, with screw fastening. Simple and low-cost case2-piece constructionFolded aluminium sheetSilver painted finish.